High-performance	Reliability
Ease of use	Value for money

Push and pull the seatback to check thatis locked. on it 1. Pull the nylon strapon the back of the seat to fold the seatback forward. From behind the bench seat, pull the nylon strap at the base of the seat torelease the rear latches from the floor pins. Do not let go of the straps until the seat is folded all the way forward. Unhook the front latches by rolling up the gray handle under the seat until handle locks. the 1-9 5. Remove the seat by rocking it slightly at the top towards the rear of the vehicle and then lift at the front latch release lever. This should be done in one motion. Place the front hooks of the bench seat onto the front two floor pins. To do this, the seat will need to be angled that so the front hooks clear the floor pins. t Replacing the Second Row Solid BenchSeat 2. With the seatstill folded forward,roll down the gray handle underneath the seat to lock the front latches. in Don't put the bench seat so it faces rearward because it won't latch that way. The solid benches have seat position labels, located on the backof the seat, showing where the seat must go. Follow that diagram. Use the C and E sets of floor A, cups. See "Seat Controls"in the beginningof this in the section for more details. The seat must be placed proper locationfor the legs to attach correctly. 1 1-10 3. If the front legs are not attached correctly, the rear legs will not attach to the rear of floor pins. set 4. Firmly push the rear hooks into the rear floor pins by pushing down on the rearof the seat. Try to raise the bench seat to check that it is locked down. 1-11 /1\ CAUTION: A seat that isn't locked into place properly can move around in a collision sudden stop. People or in the vehicle could be injured. Be sure to lock the seat into place properly when installing it...